BEHA HEATER PV10 1000W WI-FI & TIMER
Product advantages
System requirements: Wi-Fi router must be set up with 2,4 GHz og WPA2 under installation. In addition, the heater has the following functions:
- Splashproof (IP24) – The heater is approved for use in bathrooms if it is installed by a certified electrician
- Double insulated (Cl. II) – requires no grounding
- Protected against overheating – A fuse cuts the power if the internal temperature of the heater gets too high
- The temperature can also be adjusted locally on the heater, without a Wi-Fi connection
- Cable length 1,5 m
- 5 year warranty
Please note. It is important to check that the room intended for the installation of the heater has a strong wifi signal from the router. If not then this can be rectified by purchasing a plug-in wi-fi extender to boost the signal.
PV10 wi-fi Convector Heater
Technical Specifications
Watt | 1000W |
Width | 80.3 cm |
Height | 40 cm |
Depth (incl wall bracket) | 8,3 cm |
Distance between wall brackets | 31 cm |
Colour | White |
Accuracy of the thermostat | 0,2°C at 20°C room temperature |
Front panel’s Surface temperature | Maximum 80°C at 20°C room temperature |
Clear distance below the heater | 10 cm |
Clear distance sideways | 2 cm |
Clear distance above the heater | 10 cm |
Delivered with 1,5m long cable with plug | |
220 - 240 volt | |
On/off switch and electronic thermostat | |
Double insulated | |
Splash security IP24 (suitable for wet areas) | |
The wall-frame depth 3,3 cm |